Simple Setup with Instant Monitoring

Straightforward Installation Without Being a Vibration Analyst
 

How it Works

Step 1

careers

Install DAQ, Sensors

Step 2

careers

Configure Analyst InsideTM & Turn it on

Step 3

careers

Analyst InsideTM automatically goes into “Baseline Mode”

Step 4

careers

Analyst InsideTM Monitors & Adapts as issues are detected / escalated

  • Samples & Analyzes every 15 minutes
  • Uses 15+ proven vibration analysis techniques on data
  • Displays the Issue & Severity, Isolates the Source, Provides Recommendation
  • No data or waveform analysis required
 

Basic Monitoring

Monitor two points with single axis accelerometers, mounted on the motor and load OR both on the motor.

Sufficient to monitor and detect issues before they result in unplanned downtime.

basic-1

basic-config

Advanced Monitoring

Monitor four to six points, minimum of two on the motor and two on the load to provide additional coverage of machines that have a higher cost of failure if they go down. With the additional monitoring points, you will be able to detect issues sooner.

advanced

advanced-config

Critical Monitoring

By using triaxial accelerometers (which measure three points of vibration --- one each in the x-y-z axis), measure six points on the motor, and six points on the load to provide complete coverage of your most critical assets. With the additional monitoring points you will be able to detect issues sooner and have more detailed information on what needs attention.

critical

crit-config